question

forsmanf avatar image
forsmanf asked

How do I configure an Easyplus 1600 to charge lifepo4 batteries?


My Easyplus 1600 has firmware that does not allow me to connect it to my computer via the MK3-USB dongle. The battery I am using wants to be charged with a constant voltage of 13,6V. Is there any way I can configure my Easyplus to charge this battery?

Below you find a principle schematic of my system


electrical-sceme-12v.png


Here is a link to the product sheet of my batterie.

https://li-gen.net/wp-content/uploads/2021/08/Li300-spec-sheet.pdf


Kind regards

/ForsmanF


battery charging
electrical-sceme-12v.png (3.0 MiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
snoobler avatar image
snoobler answered ·

I think you're misreading that spec.


charge to 14.4V

float at 13.6V


2 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

forsmanf avatar image forsmanf commented ·
Well, no one is happier than me if the problem was solved that easy. Thanks :-)
0 Likes 0 ·
snoobler avatar image snoobler forsmanf commented ·
To your credit, that's a pretty funky and ambiguous data sheet. If I didn't have as much experience with LFP as I do, I would have been scratching my head, "WTF?"
0 Likes 0 ·