Hello to all,
I have just tried to connect my Mini SE electric to an EV Charging Station, the car is not detected, impossible to find a solution. It is the manufacturer's cable (mini type 2, 22KW Delivered with the original vehicle therefore.)
asked
EV Charging Station and Mini SE 2020 Cable type 2
Hi, please add me as admin on vrm (
lpopescu@victronenergy.com) I will help you with this issue
Hi Lucian. My Victron EV charger was installed today and I'm facing the same issue. I have 2 electric vehicles and both are show as "Disconnected" after connection with cable Type2. May I ask you for assistance?
Hi, is it updated to the latest version?
Yes. I even downloaded the new firmware today and updated the charger with this file: EVCS_Main_FW_OTA_V01.22_C025.evcsup.
Also Cerbo GX looks updated. (v2.89).
can you please invite me as admin in VRM for your system? (
lpopescu@victronenergy.com)
Not connected 
Is this the Victron EV charger? The one sold for 1500EUR? Going back to the issue, according to your picture, seems that the EV charger is not communicating with the rest of the system. I doubt your battery is at 0%...
He is well recognized, but he does not see the car
Connected : yes 
Can you test another EV with another cable?
Yes I will try this evening with another cable, but I think it comes from the Victron.
No instructions in the box, no diagram, no help, I'm a little surprised by victron this time?
@nonop4 I have replied above and offferd my help
No socket locking when I plug in the victron, I have to check if there are the dialogue voltages would you have a diagram with the output voltages of the EV charching ???
It's OK Thank you very much Lucian Popescu !
Just updating the firmware on both gx and ev charger. Currently there is no automatic update available, so I had to do it in a manual way. But it will be available soon.
