Absorption voltage too high

Question

replit

This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.

question

jonas211 asked Apr 25, '22

Hello :)

i have a MPPT smart solar 75/15 installed to a 120 AH battery.

Has been functioning good for 1 year.

Today suddenly the Absorption Voltage was too high. It was up to 14.95. for many seconds until i intervened.

In the settings i have 14.7. I even tried lowering it to 14.6. But did not change anything.

How can that happen?

I dont know how high it would have gone if I had not put something on the panel.

I disconnected the MPPT from the battery and connected it again. Then it was Ok and the charger only went up to 14.7.

Did someone have the same problem?

Thanks!

Jonas

MPPT Controllers Solar Panel voltage

46af80e3-8a15-41c8-b001-480bbdaf1054.png (203.5 KiB)

3bb7384d-0941-4a00-bfb5-b1721b255aa6.png (215.2 KiB)

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Answer 1 · 2022-04-25T17:18:12Z

snoobler answered · Apr 25, 2022 at 05:18 PM

Have you confirmed temperature compensation is off?

Have you confirmed equalization is off?

2

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

kevgermany ♦♦ commented · Apr 25, 2022 at 07:34 PM

The German in the screen shots says temp comp on, equalization off. :)

@jonas211 what's your local temperature? It's been very cold in Bavaria.

Is there another charger in the system? The MPPT will report what it sees, including voltage from other chargers.

0 ·

Show more comments