question

rspott avatar image
rspott asked

Phoenix Sine Wave Inverter 12/3000 120 Volts thinks it is a multiplus! (bump?)

I have a Victron Energy PIN123020100 Phoenix Sine Wave Inverter 12/3000 120 Volts installed.When I view it using Victron Connect it thinks it is a MultiPlus 12/3000/120-50 120V!

It even shows "L1 AC Input disconnected"

I looked at the firmware installed and it is v494.

Is the wrong firmware installed?

What is the correct firmware?

Config file is attached with a .txt suffix: PhoenixInverter3K.vcsf.txtimg-1799.jpgphoenixvictronconnect01.pngphoenixvictronconnect02.pngphoenixvictronconnect03.pngphoenixvictronconnect04.png

Phoenix InverterVictronConnect
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
JohnC avatar image
JohnC answered ·

Hi @rspott

That number on the microprocessor is the same one you'd find in an equivalent sized Multiplus. The '430' is the firmware it was originally loaded with, and 494 is the latest in that series. So you're ok there.

That VictronConnect still recognizes it as a Multi is probably a bug in VC. The developers may well be aware of it, just hasn't made it yet to the top of the 'to do' list with all of the developments happening.

I hope you can live with it.. :)

3 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

rspott avatar image rspott commented ·
Unfortunately it may be impacting in other ways. When I connect the Phoenix to my Cerbo via an MK3-USB it shows as a charge or input source and removes my directly connected VE.BUS from the Cerbo. :(


Do you know if I can roll back the firmware to a previous or factory version?

0 Likes 0 ·
Show more comments