I installed a Victron shunt with my new Dakota lithium starting battery. The shunt is wired correctly and I can see draw when I start my engine or when my graphs are on. I can also see the charge when running my engine or charging wit the charger. I've checked status while I am fishing and the draw down and recharge seems fine. The last two trips I check the status before trailering my boat and the shunt showed 92 on one trip and 94 on the other. I check again when I got home and both times the shunt showed 100%. I hooked my charger up yesterday and it charged for about 35 minutes before going into float mode so the battery was not at 100%. When I installed the shunt I charged the battery to 100% and synchronized the shunt. Any ideas?