question

tedr avatar image
tedr asked

change ET112 meter from L1 to L2 (or L3)


Just a cosmetic problem.

victron-1.jpg


In the Cerbo GX the PV-inverters connected to phase L2 and L3 are displayed as L1.
this gives a wrong calculation of the AC Loads.

victron-2.jpg

PV-Zuid is connected to L3.
Is there a solution to tell the Cerbo GX that the ET112 is connected to an other phase than L1?

Thanks,

Ted

cerbo gxEnergy Meter
victron-1.jpg (80.3 KiB)
victron-2.jpg (75.4 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

3 Answers
patricknl avatar image
patricknl answered ·

I have the same Issue with my ET112. I hope Victron is working on a solution, as far as I can tell it's a mere calculation/ missing setting issue.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

patricknl avatar image
patricknl answered ·

Additional: For now I have placed my AC-Coupled PV inverter on L1 instead of L3 to have the right numbers in the dashboard. L1 is quite a bit more crowded with PV installations than L3 sadly..

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

gesiima avatar image
gesiima answered ·

Need a better sollution for that problem too.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.