We have a bilge float switch wired into a digital input port of the Cerbo GX. After updating to 2.80, we’ve had it happen twice that the alarm stays on even after we’ve pumped the bilge dry. Rebooting the Cerbo makes it switch back to the “ok” state.
At this stage the float switch is back dow, but the state is still shown as “Alarm” and Cerbo is still beeping:
After a reboot the state goes back to “Ok”:
Since this didn’t happen with the previous Cerbo firmware, but has happened now twice after the 2.80 update, I’m assuming that this is a new bug.
Here are the settings we use:
(Somewhat unrelated, it seems “invert alarm logic” doesn’t work over MQTT. In Signal K with the Venus plugin I see the state as “Alarm” when it is “Ok” on Cerbo, and vice versa)
