Is this possible yet? Id rather not buy a Windows PC just to change my Multiplus settings.
The system will have a Cerbo GX and GX Touch 50. Is there any other way to accomplish changing setting on the Multiplus without buying a PC? Bluetooth dongle?
asked
Configure Multiplus without a PC
Unless we are doing more complex systems, I can do everything from Victron Connect.
Mk3 adaptor and otg to my phone (victron connect) works well for everything else.
So changing the settings for new batteries is possible on Connect now? Via the bluetooth dongle or only mk3?
Kind of crazy this is still so archaic and not included with the inverters at the very least. Considering how cutting edge Victron is in most ways.
To change settings you need a MK3 Interface, the Bluetooth dongle is only for monitoring.
With VictronConnect you can 'only' change the most basic settings, for more complex programming with the assistants you need to use VE.Config which is only available for windows.
In my opinion it is good that is is not to easy to access and change settings (but it is still to easy). You can easily mess up your system or damage your equipment if you don't know what you are doing.
I know this is not what you are asking but you can do it without being physically connected to the device with a pf via remote ve configure
https://www.victronenergy.com/live/vrm_portal:remote-veconfigure
You still need a pc (or a VM) to change the config file with ve configure - but then the rest is done remotely via we browser
I have to say I think the way Victron uses different interfaces and some aren't supported unless you buy special cables at insane prices is a bit disappointing when you are spending a considerable amount of money on their products.
A prime example is needing a cable for a smartshunt to PC as smartshunt via bluetooth is not supported on a PC via connect.
Appears to be a bit of a money spinner.
The lack of Bluetooth connectivity for Windows is annoying. Victron is not the only manufacturer with this issue. Microsoft needs to fix their Bluetooth stack, it's terrible.
Bluetooth works fine on everything else - Mac or Linux / iOS or Android.
As for the MK3. I'd rather just buy one of those once as a tool and not have to pay extra for its inclusion in every inverter unit.
Like if you buy 18 Quattro's for a big 3 phase system, do you want to pay for 18 built in MK3 devices to do nothing when you only need one? Maybe you don't need one at all because you already have one rattling around in your toolbox.
Even just two MultiPlus' for a split phase, I'd rather only pay for one MK3 interface device rather than two if they were built in.
I am using MAC OS X Big Sur 11.6.4 on 2013 MacBook Air and successfully updated firmware and settings in my Multiplus 3000va 12V. I have 2018 Winnebago View 24J with four LionEnergy UT-1300's in parallel, Victron BMV-712 and SmartSolar MPPT 100/50 plus 480 watts of solar panels(3). I wired system using 1/0 welding cables for intra-connections and 2/0 on the battery bank endpoints. So far the system is behaving well.
How did you do that with your Mac ? how did you connect to the Multiplus ?
