How high can the absorbsion voltage be set on a multi 24/5000
I have NiFe batteries
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
How high can the absorbsion voltage be set on a multi 24/5000
I have NiFe batteries
I have been looking at these battries can you tell me how you find them? One problem i have heard is that they are slow to accept a charge.
A good way to test any of the Multiplus settings is to download VEConfigure and run the all settings demo mode.
https://www.victronenergy.com/support-and-downloads/software
MultiPlus 24/5000/120 is being used on the vehicle.
The configuration was done as shown below.
During intermittent operation of the inverter, the low battery Alarm LED Lights up, and the inverter LED turns off.
The DC voltage is 27V or higher at this time.
If we turn the main switch off and then turn it on, it will operate normally.
Please let me know what we need to check.
6 People are following this question.