question

mike90 avatar image
mike90 asked

VEConfig "Internal error occurred" when setting up assistant.

Hi All

I get the error "Internal error occurred! Please contact Victron Energy" when I am setting up an assistant in VEConfig. I am able to do firmware updates and all other settings but not the assistants. This happens whether I am using a mk3 or through VRM remote VEConfigure.

Also each time I open VEConfigurator3 it updates the assistants.

The issue started when I had updated the first inverter to 489, after the update it had to update the mk3 and VEConfig. Since then I am unable to load assistants on any inverter. Same happens with inverters on 490 and older versions as well.

I have uninstalled, redownloaded and reinstalled VE Configuration tools but still have the same issue...

Hope someone can help.

Thanks

VEConfigure 3AssistantsMK3setup
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
Matthias Lange - DE avatar image
Matthias Lange - DE answered ·

Do you use the latest version of VE.config?

This should be fixed by now.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

mike90 avatar image
mike90 answered ·

Yes VE.config is on the latest version, each time I open Ve.config it updates the assistants. But the issue persists.

15 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Matthias Lange - DE avatar image Matthias Lange - DE ♦ commented ·
That problem should be solved in the latest version.

Maybe try to completely uninstall VE.config and make a fresh installation.

0 Likes 0 ·
mike90 avatar image mike90 Matthias Lange - DE ♦ commented ·
I have done this last week. Will uninstall, redownload and reinstall and let you know.


Thanks

0 Likes 0 ·
nickdb avatar image nickdb ♦♦ mike90 commented ·
Just also check that nothing else is connected on the VE.bus, just the MK3 and the Multi.
0 Likes 0 ·
mike90 avatar image mike90 nickdb ♦♦ commented ·
Redownloaded and reinstalled. Ve.config still updates assistants each time I oopen it and I still get the same error when trying to load an assistant.


@nickdb The same thing happens with either only a MK3 connected to the inverter or doing a remote config through VRM.

0 Likes 0 ·
nickdb avatar image nickdb ♦♦ mike90 commented ·

What version of windows are you using and have you tried a different device to configure it?

Put exclusions for the folder into your AV, etc.

When in doubt use the 3 R's - reflect, repent, reboot :)

You could also try factory resetting the inverter and then manually reapply the configuration.

0 Likes 0 ·
nickdb avatar image nickdb ♦♦ mike90 commented ·
If something is bad in the config file, it won't matter if you try do it directly or remotely.


0 Likes 0 ·
Show more comments

Related Resources

VEConfigure manual

VEConfig alternative method for VE.Bus using VictronConnect

VEConfigure Assistants manual

Additional resources still need to be added for this topic