question

magicdesign avatar image
magicdesign asked

Battery settings in VictronConnect

Hi folks. My system was set up using 4 12v 200ah batteries. The installer told me that this made the system a 200ah system at 48v.


within the victronconnect app, it displays my aH as 400 - is this wrong? Do I need to change it?

also, dynamic cut off was off. I want to switch it on. Is it best to leave the voltage settings that are there as default?


thank you

VictronConnectAGM Battery
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
nickdb avatar image
nickdb answered ·

Yes, in series you still have 200AH so that needs to be corrected.

7 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

magicdesign avatar image magicdesign commented ·
Thank you. Will it be causing any damage or just incorrect reporting?
0 Likes 0 ·
nickdb avatar image nickdb ♦♦ magicdesign commented ·
Will just affect the reporting of SOC. In an ESS setup or anything that relies on an accurate SOC this can be problematic.

You could unintentionally discharge the batteries too deeply which will affect their lifespan.

1 Like 1 ·
magicdesign avatar image magicdesign nickdb ♦♦ commented ·
Thank you again. Also, the max amp charge is also set to 100 currently. On each battery, it says 40. Should that change too?
0 Likes 0 ·
Show more comments

Related Resources

VictronConnect Manual

Download for iOS / Android / Mac / Windows

Additional resources still need to be added for this topic