I’ve got 5 smart solar MPPTs hooked up with 5 VE direct to usb cords going to a usb hub which is then going to a USB port on Cerbo gx. I see the MPPTs on victron connect via Bluetooth but I can’t get them to show up on the touch screen. Any help.
asked
I have 5 MPPT 100/50’s connected to a USB hub via VE direct to usb going to Cerbo GX. Nothing is showing up on Cerbo GX touch.
Have you tried a diffrent USB port on the Cerbo? one port is only for power.
Just tried all of the usb ports. They all seem to send power. One USB port right next to the hdmi is for the gx touch.
If you connect one of those Solar chargers directly to the Cerbo GX (using the same VE.Direct-USB cable), is it seen by your Cerbo GX?
The controllers are to far away from the Cerbo gx to do that test. I don’t have a usb coupler to go from the usb cable from the Cerbo to the VE direct to usb connection. I’m currently in La Paz Mexico and finding parts here is difficult.
from experience some brands of USB hubs do not work, try some different brand hubs if you can -
more than likely the better the quality of the hub the more chance you will have that it works
but first test the one or two MPPTs work when directly connected to the cerbo as per above advise.
Also Try
plug ONE VE direct to usb cable into your 15ft usb cable then into the cerbo this should then test if the cable is ok
Thanks for the help. I’ve got a couple different hubs coming in tomorrow from a friend flying into Mexico. Also have a usb coupler coming to just test the cable.
