This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Just hooked up a new GX TOUCH 70 and only about 3/4 of the display is touch sensitive. For example you can't click the pages button or the back button. However, you can select the menu button and scroll as long as you scroll on the right 75% of the screen.
Any ideas?
I think you may have to take it back and get it check /replaced
I have a similar issue with Touch GX70. Have you tried with another display? Did it solve your problem?
I don't know the details, but I do know that this was a known issue and the solution is replacement.
It should not occur again with the replacement (unless it potentially comes from the same old stock), so make sure it's a newly delivered unit.
It wasn't all units, so there is no need to act unless experiencing the issue.
I just have the same fault. It works with the Touch50, but the Touch70 has also the ´dead zone´ in the upper left zone.
Did you fnd a solution for this problem ? Any results ?
Did you send the touch 70 back to your dealer ?
Thx. I will send It back tomorrow . Hope the dealer will find a solution
I am having the same issue also - has anyone had the replacement screen work? It almost sounds like this could be a software bug (or a bad batch of screens went out!)
I have also just had this issue with a customer recently.
As Guy mentioned, just replace with a new one and it should work as normal.
