Hi everbody
I would like to customize the User Interface of a GX Cerbo / Touch 70 so that I can replace / enhance the control panell of my RV (Niesmann & Bischoff Clou).
The User Interface should in particular allow for switching of/on the water pump in the RV without having to schroll through the menue. Same goes for the motor pre-heating via the heating system of the RV.
The Components consist of a MPTT Charger, Orion B2B charger, Smart Shunt, 4 Temperature Sensors and Multiplus. This is networked via a Cerbo GX and Touch 70.
In addition it would be very handy to read out some temeperatures (fridge, outside / inside temperature) and configure triggers / alarms in so far certain thersholds are met.
Reading here, I get the impression that the realisation of my "wishlist" should be feasible.
I would be gratefull for hints / advice of alike solution or a guide for "dummies" that eases a beginner (like me) to endevour a customized User Interface.
Best Regards
Martin