question

Was avatar image
Was asked

Easysolar-II GX Screen does not show battery state of charge

Easysolar-II GX Screen does not show my battery bank battery state of charge. How can i get it to display this info please ?

EasySolar All-in-One
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
Matthias Lange - DE avatar image
Matthias Lange - DE answered ·

Do you have a BMV/SmartShunt or a Can.bus battery or have you activated the internal battery monitor of the MultiPlus(with VE.config)?

More information about your system please.

4 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Was avatar image Was commented ·

thanks for the quick response,
here's the error message (attached) am getting when i enter my VRM Portal ID
screen-shot-2021-10-14-at-90206-pm.png
Regarding the batteries, i don't have a BMV/SmartShunt,
my battery bank is a 48v (12v 200amp X 4 batteries), Gel deep cycle batteries.

0 Likes 0 ·
screen-shot-2021-10-14-at-90206-pm.png (56.7 KiB)
Matthias Lange - DE avatar image Matthias Lange - DE ♦ Was commented ·
Than you have to activate and configure the internal battery monitor of the MultiPlus.

Read the manual for that.

https://www.victronenergy.com/media/pg/VEConfigure_Manual/en/warning.html

0 Likes 0 ·
Was avatar image Was Matthias Lange - DE ♦ commented ·

how can i access this section please ?

as i told mentioned, i cant into that section because the VRM Portal ID is not working :(

0 Likes 0 ·
Show more comments