question

cstenger avatar image
cstenger asked

How to switch off the MPPT with ignition on

Currently I have my 75/10 MPPT and Orion 12/12-30 wired up in parallel to the battery, which is totally fine. But I recognized that with alternating Solar input whilst driving (shaded by trees, bridges etc.) the voltage is jumping and when starting the car after the engine was off and the MPPT took over, it takes a while for the Orion to realized it should start working. Sometimes it doesn't even put out any voltage/current until the solar panels were shaded for a longer period of time.

I want to avoid this by switching off the MPPT when the ignition is on.

How can I manage this, what cables and components do I need?

MPPT Controllersorion-tr smart
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
pau1phi11ips avatar image
pau1phi11ips answered ·

Just use a relay powered by the ignition on to break the remote contact on the MPPT.

8 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

cstenger avatar image cstenger commented ·

I'd like not to use a relay, at least no mechanical. Do you know a MOSFET relay with an NC contact?

0 Likes 0 ·
Matthias Lange - DE avatar image Matthias Lange - DE ♦ cstenger commented ·

You could try to use the "inverting remote on-off" cable.

https://www.victronenergy.com/accessories/inverting-remote-on-off-cable

0 Likes 0 ·
Show more comments