Hi Guys, please can anybody tell me where the green wire from pin 2 goes to the bms controller. Thanks
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi Guys, please can anybody tell me where the green wire from pin 2 goes to the bms controller. Thanks
https://www.victronenergy.com/support-and-downloads/software
Above is the link to the configuration software for the converter. It looks like pin 2 is intended as an output. However, if you have it configured as an input, I think it safe to assume it follows the same rules as pin 1. (if >2V, the unit will enable if the supply voltage is >= (adjustable) volts and any blocking is over). This should be tested first.
You then need to find the charge control relay output from your BMS (type ?) and arrange that this pin is grounded when charging is disabled and pulled up to the input voltage at other times.
26 People are following this question.