question

flokstra avatar image
flokstra asked

Lithium superpack 100ah discharge

Hi there!

Been searching the forum for an answer, but no luck so far.

I've got a setup with a Lithium Superpack 12v 100Ah, mppt solar, orion-tr smart, multiplus 1200 and a bmv-712. Everything functioned fine over the last two months. I've put away the van for a few days now. When i came back, the bmv was sounding the alarm and reads only 9,8V. All dc loads are disengaged or turned off. Only the bmv is connected.

How can the voltage drop that low? As I understood the internal bms of the superpack should've disconnected the load long before reaching 9,8V! And on top of that, the bmv is the only (tiny) load connected. How is this possible?

All help is very much appreciated!

ee4efca5-de12-47c8-ab29-93e041687b99.png

BMSSuperPack
ee4efca5-de12-47c8-ab29-93e041687b99.png (334.3 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
Alexandra avatar image
Alexandra answered ·

@flokstra

Don't know if this is the case for you as I have never used a victron superpack. but I did have some lihtiums go into a low power mode in storage, also reading 9.8V had to use the bms wake up procedure in the manual for the product. So the batteries were charged the bms had shut down due to inactivity.

2 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

flokstra avatar image flokstra commented ·

Hi @Alexandra !
Thank you for your answer. I searched around this storage mode a bit, but didn't find anything. It's supposed to shut off at 10V, and then After sind me time of storage i can understand the bms taking it down to 9,8. But within a few days is crazy. And it also didn't even shut down yet as the bmv was still up. I'll take the multimeter to the superpack tomorrow and check if there's any voltage difference between what the bmv reads and what's actually there.

0 Likes 0 ·
Show more comments
Paul B avatar image
Paul B answered ·

WAS it full in the first place it was it at 14.2 volts when on charge - before you disconnected it. or were you looking at the SOC and seeing 100% so presuming it was full . Voltage is always a better indicator of charge level

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Related Resources

Victron VE.Bus BMS product page

Victron 3rd party BMS compatibility page

Additional resources still need to be added for this topic