I recently added a Cerbo GX to my system to get remote information and warnings of out of parameter (low voltage primarily) system readings. When I boot my MPPT connected via VE.Direct to the Cerbo, I cannot see the MPPT on VictronConnect and I can see it on VRM. If I disconnect the VE.Direct cable the MPPT immediately appears on VictronConnect. I can then connect via VictronConnect and get complete access. If I then connect the VE.Direct cable, I can still see the unit on VictronConnect, but it gets hung up in a loop of loading data and then reconnecting. I can see all expected data on VRM when connected with the VE.Direct cable to the Cerbo. My BMV-712 works flawlessly both via VictronConnect and VRM. Suggestions?