What should this mean?
My interpretation is Charging is allowed and discharge is not allowed.
What it really means in my ESS instalation.
"Discharge is not allowed, but charge at maximum current possible."
When "Allow to discharge" is set to NO, the "Low battery"-led starts to flash, and multiplus starts to charge with maximum charge power, it disregards state of charge, it ignores ESS set points... it just charges.
I use the 2-wire BMS assistant with ESS.
The allow to charge works as it should. When NO it stops charging, when set to YES it charges, if ESS grid point allows it.
I am on latest firmware on the multiplus-II and VenusOS is 2.80-ish (same behaviour on lower venusos as well)
Is this not a bug? Am I the only one?