This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Lately, currentflow in VRM was adapted so that my fronius on ac-out is shown the right way.
But the dots are moving not correctly.
See the picture -> Fronius produces 2717w and house takes 481w.
So the dots should move from Fronius to our House (AC-Lasten) and to Victron. (green arrows)
But wrongly the dots are moving from Fronius to AC-Lasten and from Victron to AC-Lasten aswell. (red arrow) This is wrong as Fronius is feeding into grid, as victron does, too
I reported this some time back as well.Not a priority i guess.
Also the DC biased over AC coupled bug with the fully off grid setups still exists.
With an AC coupled off grid system when the battery SOC reaches 100% the subsequent loads should directly covered by the AC coupled inverter, which is the most efficient way of doing so because of the single conversion from DC to AC then direct consumption.
At present when the system is 100% SOC the AC coupled PV inverter is ramped down through frequency shifting and the loads are covered through the MPPT's and the Multiplus.
