This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi, I recently installed a second multiplus 12/3000/230 on my boat, in parallel with the first one, works great ! But Max 230VAC ouput power is too much for my batteries and also for my DC cables&fuses installation. I don't want to limit the ouput with a 230VAC breaker (say 16A would be fine) because I can use a little more when connected to the dock. IS there a software limit I can set on the multiplus ? thx !
This is not possible, as the inverter will just try to keep up with your AC use.
So you are the limiter.
Some options / work arounds:
-You can put a lower value breaker on the output to stop using too much power (but you didn't want this)
-You can use the AC-2 output to power heavy users, and let this output disconnect when using too much power - or let this output only switch on when there is AC available on the input.
As you have quite a bit of power available, you'll have multiple circuits. so make one (or two) of them for 'heavy users' and let them switch.
A software limit would be easier but I will look at the ac2 output solution ! thanks !
You may also want to consider using a 400A fuse instead to provide a little more buffer before tripping - 400A is the Victron recommended DC fuse size for a 12/3000 Multi.
I also just checked the standard available ANL fuse ratings vs physical size. If you are already using a 350A fuse, the larger size should bolt directly into your current fuse holder;
You could also configure an 'assistant' in the Multi to trigger an audible alarm.
AC2 could also be used to ONLY run the induction cooktop for example - that way if it cuts out you will know why.
Finally, you may want to consider a high current DC circuit breaker instead of a fuse - but it will be difficult to find one with a 400A rating. 'Noark' sell a range of high current DC circuit breakers (MCCB - Molded Case Circuit Breakers) which you could look into but they are not cheap. I use them in my own install.
