This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
All,
I have done hours of research on which tank level senders will be compatible with the CERBO GX. I found an old thread that listed these (https://kus-usa.com/product/sss-ssl-sender/) as compatible without any adapter. Meaning, I could wire them directly to the CERBO. However, I am not getting any signal and the CERBO simply says (Not connected). Do I need the CANbus adapter for these to work?
Thank you!
That one works. You need to go into the settings, I/O, analog inputs and turn on the sender you are using. Then go back to the front menu and you'll see the tank level. Click on that, click setup, change the sensor values to 240 empty, 30 full ( You can dial both of these numbers in later when you figure out what settings work best for you). This is also where you will pick if this is for fresh water or waste water and that will show up in your VRM. I also recommend going into the main settings, go to system setup and turn on has dc system. It's a great layout that also gives you visuals of the tank levels. You can also change the logo on the page to your own which is fun.
Thank you for the help! I knew I was not losing my mind. I will give this a shot tomorrow and let you know where I land. Should be good to go!
I also have a KUS sensor connected to cerbo GX. Says not connected in device list. If I click on device and choose setup it says connected and shows a resistance value for the device. I can’t figure out where I am goin wrong here.
