article

rolandka avatar image
rolandka posted

BMS controlled Multiplus (T-Sense and AUX ports voltage)

Hello there,

I have Winston LiFePo4 batteries and a BMS. The BMS has two signal relays that could control other devices. (Allow to charge, allow to discharge)

Now, both signals output 12V and I was wondering if I can connect that directly to the AUX and T-Sense ports on the multi (without optocoupler)? Of course, I would install and activate the “Two Signal BMS Assistant”. However, I'm just not sure if I can feed 12v to the ports?


Thanks in advance

MultiPlus Quattro Inverter ChargerLithium BatteryBMSAssistants
3 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

wkirby avatar image wkirby ♦♦ commented ·

No, please don't feed 12V up those ports. Opto-isolators would be best, I do this with my BMS. Otherwise relay contacts.

0 Likes 0 ·
Show more comments
rolandka avatar image rolandka commented ·

I realized that i somehow posted this to the wrong section.. It should be in questions. Can someone move it?

0 Likes 0 ·

Article

Contributors

kevgermany contributed to this article rolandka contributed to this article