TAB: GeneralSystem frequency	50Hz

Shore current	10.0	A
Overruled by remote	checked
Dynamic current limiter	unchecked
State of charge when Bulk finished	85.0	%
Battery capacity	200	Ah
Charge efficiency	1.00	TAB: Grid
Country / grid code standard	None:                   (feeding energy from DC to grid not allowed)

Accept wide input frequency range (45-65 Hz)	checked
AC low switch mains off	180	V
AC low switch mains on	187	V
AC high switch mains on	265	V
AC high switch mains off	270	V
UPS function	checkedTAB: Inverter
PowerAssist	checked

Assist current boost factor	2.0	
Inverter output voltage	230	V
Ground relay	checked
Inverter DC shut-down voltage	37.20	V
Inverter DC restart voltage	43.60	V
Low DC alarm level	43.60	V
Do not restart after short-circuit (VDE 2510-2  safety)	unchecked
enable AES	uncheckedTAB: Charger
Enable charger	checked

Weak AC input	unchecked
Stop after excessive bulk	unchecked
Lithium batteries	unchecked
Storage mode	unchecked
Use equalization (tubular plate traction battery curve)	unchecked
Charge curve	Fixed
Absorption voltage	55.50	V
Float voltage	55.10	V
Charge current	26	A
Repeated absorption time	0.50	Hr
Repeated absorption interval	1.00	Days
Absorption time	8	HrTAB: Virtual switch
TAB: Usage
Virtual switch usage	Do not use VS
TAB: Assistants
TAB: Assistant Configuration
PV Inverter support (size:757)

*)	The solar converter will start reducing its output power at 50.10 Hz.
	Output power will be reduced to minimum when the frequency is  51.00 Hz.
	The converter will disconnect when the frequency is higher than  53.00 Hz.
*)	Total installed PV inverter power is 1500 Watts.
	Total installed PV panel power is 1500 Watts.

programmable relay (size:175)
*)	Use secondary programmable relay K1.
*)	Set relay off
*)	in case of a general system failure.
*)	when SOClower than 80%.

programmable relay (1) (size:30)
*)	Use secondary programmable relay K1.
*)	Set relay on
*)	when SOChigher than 99%.


Total size of all assistants including the required
(hidden) system assistants is: 1044