Hello everyone, I’m looking for some guidance on how best to configure my smartshunt. It has been physically installed correctly will all sources funnelling through it prior to the battery bank that is made up of two Lithium’s for a total of 540ah.
The problem I’m having is; the batteries are current at 85%, I know this through the BMS however the shunt is reporting 100%. Here are my settings, sure wish there was a way to post a screenshot
Battery capacity: 540 ah
Charge voltage: 13.4
Discharge floor: 10%
Tail current: 4%
Charged detection time: 3m
Peukert component: 1.05
Charge efficiency factor: 99%
Current threshold: 0.10 a
Time-to-go average period: 3m
Battery start synchronized is on
I’ll wait until the charger goes to float and the batteries are known to be 100% then I’ll manually synchronize. I’d hate to have to do this every time though.
Appreciate any assistance.
