This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hello, I have an association problem between my quattro victron and a Fronius
All conditons are programmed on the fronius and the quattro but the screen of the controller always displays an injection in the grid
It is well configured in zero grid injection
Please post a wiring diagram of your system.
The schema of my installation is as follows:
Make sure you correctly setup the inverter location in the settings.
Hi,
The inverter fronius is configured in MG 50hz, Zéro injection Fronius is active on the ccgx victron :
I may be forgetting something ?
In order to recover the power of the Fronius for my batterries I have (for example 1800w) to set "limit load power" to 1800w, otherwise I lose in the grid the power of the fronius
without this function the Fronius decreases the power of the Pvs
