A failure got me thinking today,
We had the coms fail between the DMC panel we use to control the 2 multis on this particular install. This means the panel no longer operates in GEN mode but operates normally of course. a pain as the install is on a boat 800 miles away from me and the idea of the panel is that it can't be set to overload the generator!
I was wondering if the same functionality as the DMC could be built in to the GX device.
The GX Device, when there's no DMC panel, can control the AC current limit so why not allow the current limit to be set by the Software condition of the generator control relay feature in Venus.
I could then do away with the DMC panel completely and would simplify the wiring.
I know I could wire up so the GX device tells the multi to start the generator but that's quite an involved install and a lot of assistants which might prove difficult to explain to someone else!