This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I have installed a 3 phase system (3x15kVA Quattro) with 8x 250/100 MPPT's.
The system however is not utilising the solar for all 3 phases but only for the red phase which is also the master inverter. I also noticed that the "inverter on" LED is flashing on the master unit while the mains on all 3 units are solid.
Additionally it is keeping the batteries charged at all times although I have the SOC set to 30%. The other 2 phases are pulling the power from the grid.
Any ideas?
It was actually the fact that the other 2 inverters did not have the assistants loaded on them therefore it was only feeding the 1 phase.
Once I added the assistants to the other 2 units it is all functioning properly.
All fixed as per last post from @Alexandra
It was actually the fact that the other 2 inverters did not have the assistants loaded on them therefore it was only feeding the 1 phase.
Once I added the assistants to the other 2 units it is all functioning properly.
