I have a security system on my motorhome that will remote start the engine and run it for 20 mins and repeat that 3 times. The method to trigger the remote start is to ground the remote start input on the security system.
I have run a ground wire to connect to the COM and second wire to connect from the NO to the input of the remote start and understand how to set the relay. However, it is not intuitively obvious how to physically connect the two wires to the connector on the back of the BMV-712. The body of the connector with the NC, COM and NO points are green and I can see metal in each hole. In addition there is an orange plastic tab on the side of each hole. I have gently poked a wire in to attempt install and also used a tool to attempt to move the orange tab without success.
For most connections of this type, I insert the wire and tighten down a screw to lock the wire in place.
I am sure there is a simple method to install and remove a wire from the connector. I would rather know the method then experiment and possibly break the connector.
I have not found any documentation in the manual or on the web that explains how the connector operates.
I thank you in advance for your kind guidance.
Larry