This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I have a centuar 12 VDC / 40A charger with a house battery bank of 300 Ah. When I start my generator the charger goes to approximately 50A and will continue to charge for approximately 30 - 60 minutes. The current at that time is approximately 35 A and than the charger switches to float prematurely in my mind. Batteries are not fully charged. I have checked and the charger did not seem too hot and the fans were still running. Is this the expected behavior? Thanks Rob.
We would need to be advised the voltages that the batteries are getting to to be able to help
The bulk Absorption and float are basically all controlled by the voltage settings. and the battery type selected (If applicable).
These are all listed in the manual
The battery setting is set to lead acid, dip switch 1 on and 2 and 3 off. The voltage is close to 14.2 and the current was around 30A. I checked the temperature of the charger and it was only warm not hot. Fans were still running as well. When I switched off the charger for a couple of minutes and than turned it back on it carried on in absorption for another 90 minutes until I shutdown the generator when the charger was at 10 A. Does this help?
