This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Downloaded yesterday the software package for Quattros.
Have a MK2 interface which I have used before.
Ve.Bus system configurator cant detect the com port.
First tried it on a three phase system and could not connect, then went to our boat where is a single phase system and same.
The ethernet cable is OK, the MK2 interface is ok and detected by windows.
Did you load the drivers?
With my MK3 it was 2 part process.
First you tell the system that the MK is connected and than you load the drivers for it.
On the download page it says,
*On computers with internet, Windows will automatically download the correct driver itself. *
But now I did download the drivers anyway and installed it, tomorrow will see if the problem was solved.
I took a old computer with Win7 and got the MK2 working.
Still the problem exist with MK3 and a new Win10 laptop.
Check if the driver is installed correctly and install it manually if needed.
https://community.victronenergy.com/questions/72307/connection-issues-with-mk3-and-laptop.html
