question

mikko-juuti avatar image
mikko-juuti asked

AGM charging current selection on Dolphin charger

Hello everybody,


I have 3 x 12V 95Ah AGM's in parallel and plan is to charge the bank with Dolphin charger when connected to shore power.


Which of below modes you'd choose for setup? If I got it right, "Calcium lead" mode would have the right voltages? I'm planning to use one of the posts of charger to connect the starter battery which is a traditional 12v battery so it would need the "Wet & flooded" option but which one you see would be a best option for this combo with 3 AGM and one wet battery?


Cheers, Mikko


1618466473996.png

1618466777927.png

battery chargingAGM Batteryshorepowerbattery connection
1618466473996.png (72.2 KiB)
1618466777927.png (39.0 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
wkirby avatar image
wkirby answered ·

When setting up charging profiles, you need to get the information from your battery manufacturer's datasheet and then work from there to set up your charger correctly.

Also, we shouldn't really advise on the Dolphin charger because this community is a knowledge base Victron equipment only.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Related Resources

Additional resources still need to be added for this topic

VictronConnect VE.Bus charging manual