I have a multiplus ii 48/5000/70-50, DC PV array, Battery with built in BMS, MPPT and CCGX running ESS.
I want the system to run grid independent - using only PV and battery unless battery gets too low or load gets too high.
We have a very unstable AC input with large fluctuations of input voltage that result in regular inverter overloads and grid disconnects, even when the grid is available.
We have used the programmable relay assistants to prevent AC 2 out disconnect with the grid disconnections. (This is working well)
I want to use the Generator Start - Stop assistant to ignore AC input above a specified SOC and below a specified AC load. The point is to minimise exposure to the unstable grid input, but have it available when needed.
I have created the following config... not yet uploaded...
Will the assistants work together to give the outcome described above?
Is the order of the assistants correct?
Is there anything here that could cause damage to my system or electrical appliances connected to it?