question

jbakuwel avatar image
jbakuwel asked

MultiPlus-II, CT, AC current sensor assistant

Hi all,

I need to add a CT to an ESS system using a MultiPlus-II.

The plug has been cut off the CT (wire not long enough). Instead of re-adding the plug and using the designated CT sensor input on the MultiPlus-II, can I also connect the CT to the Aux 1 of the MultiPlus-II and use the "AC current sensor assitant" for that purpose?

Do I also need to enable the "External current sensor connected (see manual)" in VE.Configure? Or is that referring to the designated CT sensor input on the MultiPlus-II only?

Jan


Multiplus-II
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
bonie-wanda avatar image
bonie-wanda answered ·

My understanding is that the usually blue current sensor that connects with that aux-like endpoint inside the multi does not need a change in settings because the multi treats it like the internal component.

it’s only when you have an externalmeter like the ET112 which that you change the settings.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Related Resources

MultiPlus-II Product page 

MultiPlus-II Manual

Multiplus-II GX Online Manual

MultiPlus-II 230V Datasheet 

VE.Bus Error codes

Additional resources still need to be added for this topic