Help setting up a 100-20 controller, wiring is correct, no blown fuses, it only shows voltage, under output, (state is on and current is 0 despite running an inverter).
Battery only shows voltage with current 0 and state is off.
Under solar, volts/current is both 0 with panels connected?
Under solar, minimal sun.. 10 volts coming in - (should be detected)
Under Battery - just volts despite load from inverter,
Under Load - Zero
My connections on the Victron 100-20 MPPT Controller are as follows:
Battery is connected with heavy wire to the Lithium 100/ah battery with a on/off relay so it doesn't drain the battery when not in use,
PV is connected to the panel,
Under Load on the controller - its left unconnected,
I was told to leave this alone.. is this correct?
in there a video for US versions that show how to set this up?
I was able to set up my battery correctly for lithium..
This is for my "Solar Generator Project" which uses a 100/ah lithium battery, 1200 watt inverter,
Smartsolar charger controller w/bluetooth 100-20, and then finally all that is set and programmed.
I would setup my Victron MPPT Control (Remote for Victron Blue Solar - Solar Charge Controllers)