Hello all,
I have a Quattro 24/5k/120 x (2), and Cerbo GX, and (3) Pylontech compatible batteries with 400Ah for about 1200AH total. I connected per Victron's Pylontech documentation and see that the Pylontech registers as a present. I'm just not seeing any voltage, current, temps, etc...
Has anyone experienced this? Any ideas where to start looking?
I've confirmed the cable pinout on CAT6 + shielding (run-length about 10'), dip switches on Pylontech batteries, CAN termination, etc...
Quattro firmware is 276 and Cerbo firmware is v.2.60
Pylontech battery reads 0s
Plytontech batteries are connected and talking - not sure if talking properly
Quattro is registering DC voltage from batteries:
High-level system schematic: