ET112 / Cerbo GX setup not detected.

Question

replit

This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.

question

michelg asked Sep 14, '20

Hi everybody !

Just finished installing the ET112, the leds are correctly blinking on it, but for any reason, the Cerbo GX is not detecting it.

Hardware : USB to RS485 5m from Victron.

Cerbo GX : Fw: 2.60

USB position on the Cerbo GX : 2 (middle connector - 1 is the left not used, 2 = middle used by USB to RS485 , 3 = Cerbo 50 screen power)

Any idea, suggestion or fix welcome, thanks.

Michel

cerbo gx rs485

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Answer 1 · 2020-09-14T13:05:34Z

michelg answered · Sep 14, 2020 at 01:05 PM

Issue fixed by moving a few centimeters the RS845 cable from the path it was using !

victron-vrm-et112-1.png (29.4 KiB)

victron-vrm-et112-3.png (29.2 KiB)

victron-vrm-et112-2.png (20.3 KiB)

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.