On my Victron Multiplus, I noticed that when I am pulling no current from the L1 output but the L2 output is pulling current, the Victron App applies all of the current pulled from L2 to the L1 output measurement in the app.
Is this expected?
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
On my Victron Multiplus, I noticed that when I am pulling no current from the L1 output but the L2 output is pulling current, the Victron App applies all of the current pulled from L2 to the L1 output measurement in the app.
Is this expected?
MultiPlus Product page / Quattro Product page
MultiPlus 230V Manual / Quattro 230V Manual
MultiPlus 230V Datasheet / Quattro 230V Datasheet
VE.Bus Error codes / VE.Bus configuration guide
Additional resources still need to be added for this topic
26 People are following this question.