question

arni avatar image
arni asked

Conecting wind turbine two “Cerbo GX” and displaying in “VRM

Hi I'm adding a wind turbine to my setup. And I would like to measure the power coming from the wind turbine. I have a remote system and I'm using “Cerbo GX” and “VRM”.

cerbo gxVRM
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
Paul B avatar image
Paul B answered ·

Hi Arni, as the information supplied is not complete enough to answer.


I have given you a guess answer based on the below


Presuming that you also have a Multiplus or quattro in the system you could connect the wind powers output through a Victron current sense coil unit (max 7Kw) per unit and then use a few assistants in the quattro or multiplus to display the wind power but as a SOLAR input as there is no other option available currently on the Cerbo display, this would then add to the total solar input if you have any if you have that but it should show on the VRM as a separate input if you do have solar as well I think.



2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.