Hi,
I just upgraded my raspberry with the newest developer version.
something is not right:
I use the following:
bluesolar charger MPPT 75/15
Phoenix inverter 12V 500 VA 230V
BMV-700
21 AH 12V LiFePO4 battery
raspberry firmware: v2.60~35
all Victron devices are attached to the raspi using way too expensive Victron usb dongles.
all firmwares are the latest of today (22 july 2020)
I attached a 200 Watt non-inductive load (Infrared philips lamp) to the inverter.
According to my AC load on the display of the raspi it uses an ac load of 240W. That's seems ok- altough a bit high (perhaps the Philips ir lamp uses more than its rated value).
Problem:
The soc goes down a lot faster than anticipated. In addition, the output of the VRM portal shows a load of 496W.
Something is not correct.
Anyone any idea what to do?