This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
VICTRON MULTIPLUS 12/1600/70 COMBI internal red LED
I set this up 6 months ago and was working fine. Then I altered the dip switches 3 and 4 then stored the settings by moving Dip switch 8 to “on” and back to “off”. Ever since this internal red LED has illuminated but everything else seems to work fine. Can anybody please tell me why this light is on and what it means?
Manual appendix A:
Thanks for this, I missed this on the Appendix. However, I am still not sure why it has lit or what to do about it... As I mentioned it came on after I changed some dipswitches but this states that it is not adjustable with DipSwitches. Is it only an alarm/pre-alarm for the three reasons mentioned or could it indicate something else? I have a control panel connected, could that have something to do with it?
Programmable relay By default, the programmable relay is set as an alarm relay, i.e. the relay will de-energise in the event of an alarm or a pre-alarm (inverter almost too hot, ripple on the input almost too high, battery voltage almost too low). Not adjustable with DIP switches. Near the connection terminals an LED illuminates when the relay is activated (refer to S, see appendix A)
As long as you have nothing connected to the relay you can ignore it.
If you want to use the relay you should use a MK3 interface and VictronConnect or VEconfig.
This are the default settings.
The relay will switch on if any of the alarms is on (2nd pic) and will switch off if non of the alarms is on.
