It was suggested that I post this as a new thread.
I have four roof panels connected to a 100/50 controller and two ground deploy panels with its own 100/30 controller. The settings on both controllers are identical. When I last used the roof and ground deploy panels everything worked fine. Now this issue has popped up:
The groun d deploy panels are working fine (100/30), but the roof panels (100/50) shows volts and no amps or watts.
I’ve unplugged the roof panels and the voltage drops to zero as expected. I disconnected the 100/50 controller from the panels and the battery, disabled the 100/30 charger in the app, and reinstalled the 100/50 per the directions. It didn’t solve the issue with the 100/50 showing voltage and no amps.
Since the controller can see both the panels and the battery I don’t believe it’s a curcuit breaker. I also don’t believe there’s one in my installation.