question

peterako avatar image
peterako asked

Mppt 150/75 setup as 24V is changing its voltage setting

I have installed a MPPT 150/75 connected to a 24 Volt battery bank. 2 days ago the battery dropped by mistake to a very low voltage (0% charge) . the next day when the sun came back the MPPT charger started as a 12 Volt battery as a result the battery (24V) never re filled.

My question is this normal or how can i avoid , i do have the connection cable and software to adjust the settings and monitor.

MPPT Controllers
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
Daniël Boekel (Victron Energy Staff) avatar image
Daniël Boekel (Victron Energy Staff) answered ·

Hi @peterako

What firmware version is on your MPPT?

2 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

peterako avatar image peterako commented ·

After the 1st time that i connected my computer with the victron connect software it updated to version 1.48.

Tomorrow i am again on the site there are five independent systems installed i have this problem with only 1 system the other 4 respond perfect.

0 Likes 0 ·
Daniël Boekel (Victron Energy Staff) avatar image Daniël Boekel (Victron Energy Staff) ♦♦ peterako commented ·

Hi @peterako

so this happened before you updated to 1.48?

0 Likes 0 ·