I have installed the BVM-712, and the Smart MPPT 100/30. Currently I have 2 - 170W panels along with 4 Decka DC24 batteries. (specs below, will be replacing them soon)
The issue I am having is the reporting of the BVM, I believe I have the settings correct. And have done the sync SOC to 100 and zero current calibrations. But the readings are not what I think are accurate. the SOC is saying 60% yet the voltage is at sub 10V. I was told the discharge floor setting would adjust your amp hours and display to accommodate but it seems to be in reverse. Did I mess up the settings? How do I make sure its information it reports is accurate?
On the 100/30 I did "User Defined" using the numbers provided by the manufacturer but there is no setting for "Bulk" and I never see the bulk charging above 13.8 any recommendations?