The thermistor(?) on the BTS probe of my MPPT 1224-40 charge controller has broken off.
It was connected to the controller via an RJ45 connector. On each tails of the encapsulated thermistor there was a resistor soldered in series: one is 10k and the other is 76k.
I have a replacement sensor (genuine victron Im advised) that has the following characteristics : 96k at -20C (freezer), 10k at 20C (room temperature) & 1k at 100C (boiling water). Would this be a suibale sensor to solder in series with the existing resistors please?
Alternatively, can anyone advise the resistance characteristics of the BTS probe please?
Many thanks in advance