Der All,
following issue,
My AGM 48 Volt battery system is not following the routine charge routine (Bulk-Absorb-Float) but basically stack in float mode and the corresponding voltage.
Maybe someone can tell me why the system is not starting the day in the normal bulk mode and increasing the voltage until absorption voltage is hit?
The weather is usually allowing this voltages and the batteries are in the morning down to SOC 70%.
In ESS the system was working properly, in HUB 1-3 it isnt.
My system:
My Multiplus-II in Hub-1-3 configuration (normally disconnected from the mains).
Previously I used ESS but I prefer islanding due to legal reasons, In ESS i did not have these problems.
Venus GX, AGM 48V 6 Kwh battery system.
FYI i played already with the "repeated absorption interval" setting, no changes.
