How do i connect Fronius Primo 8.2-1 with Victron Quattro 48/10000? Are there any available drawings?
@Guy Stewart (Victron Community Manager)@Johannes Boonstra (Victron Energy Staff)
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
How do i connect Fronius Primo 8.2-1 with Victron Quattro 48/10000? Are there any available drawings?
@Guy Stewart (Victron Community Manager)@Johannes Boonstra (Victron Energy Staff)
There are two options. Install the fronius on the AC distribution on the INPUT side of the Quattro, so it only works in times there is AC input avaiable. Or have it connected on the AC out Acdistribution which means it works also in inverter mode. If doing so, make sure the PV assistsant ( which can throttle down the fronius when the battery is full) is installed.
Further to @Johannes Boonstra (Victron Energy Staff) answer:
This single line diagram shows conceptually where it can go:
This one is my preferred location when off grid (and DC solar is not part of the system as well). As it means the loads will be disconnected before the inverter shuts down, and allows the system to automatically recover when the sun comes out again.
Victron with AC PV online training
AC-coupling and the Factor 1.0 rule
AC-coupled PV with Fronius PV Inverters
Connecting a PV Inverter section of GX manual
MultiPlus Product page / Quattro Product page
MultiPlus 230V Manual / Quattro 230V Manual
MultiPlus 230V Datasheet / Quattro 230V Datasheet
VE.Bus Error codes / VE.Bus configuration guide
AC-coupled PV with Fronius PV Inverters live docs
Fronius Webinar: Fronius & Victron Energy: Easy system set-up
Fronius Advanced Webinar: AC Coupling with Fronius & Victron (AFR)
Fronius Webinar: Smart rural electrification with Fronius and Victron Energy
Additional resources still need to be added for this topic
16 People are following this question.