This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
300Ah LiFePo, 3KVA Multiplus, BMV712, MPPT 150/85, CCGX
The system is 8 weeks old and I have just noticed that the installer has set the tail current to 1%. The general recommendation seems to be 4%. The system has performed 8 syncs in the past 8 weeks. Should I increase the tail current setting?
how many times the batteries were fully charged in this time? (based on voltage, if you can see this, is the system online?)
(I'm assuming your talking about the battery monitor)
2% or 3% will probably work fine if the charged voltage is set correctly.
Thanks. I have reduced the charge detection time to 3 mins and have had a sync within the hour. I'll see how this goes before increasing the tail current.
Fully charged voltage is set to 13.5v and the time is set to 30 mins. The batteries (3x100AH) spend most of their time at 13.5v as we have shore-power all the time and we are only using the batteries for Power Assist.
I have mine set at 1% (4A on my 400Ah LiFePo4 set up) as suggested by a Lithium "guru" from South Australia. He also suggested 13.9V as the "Charged Voltage" setting. Charged detection time set at 1 minute.
