This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Setup:
Victron Multi Plus 48/3000
Color Control
2 x Pylontech 2000 Batteries
Smart Solar 150/35
I configured my Setup with the help of this victron offical tutorial https://www.victronenergy.com/live/battery_compatibility:pylontech_phantom
Problem:
Multi Plus shows always "Battery low voltage" warning.
Question:
What could i have done wrong ?
Thanks for the support
Hi Inigodu and Oemmes,
Did you both read the section in the Pylontech Victron manual 4. VEConfigure Settings ?
"Due to the reliability of the grid supply and the behaviour of the sustain voltage threshold in ESS; you may wish to suppress the low voltage pre-alarm warning so that it does not trigger every day on its regular deep cycle. See ESS FAQ Q5 - about suppressing the low-voltage alarm."
There is too little information provided relative to your question.
You can submit some CCGX information photos or the measured system battery voltage is a value, etc.
Good luck
Using VEConfigure3, look in to see/change your 'low batt' setting. Maybe under Inverter>'DC input low pre-alarm'. Ask again if you need help doing that.
Might not be the issue either, but you'll enjoy the learning experience. :)
